Low Temparture Chest Freezer

Super-Cold Chest Freezers (0°C to -45°C)

Model Numbers: 40-9.4, 43-1.7, 45-1.7, 45-6.8, 40-12

  • Electrical requirements: Depending on voltage and hertz ordered
  • Location must provide enough room to open lid to at least 75°
  • 3" Minimum distance required from back of unit to back wall
  • When planning a recessed installation, add 3" of air space to each side
  • Unit does NOT accept custom panels
  • Not recommended for built in installation
Custom Repackaging of Aerospace Consumables Ask about our Shelf-Life Discounts
  • Aviation Fluids Service, INC. LogoMCS 2361 Non-Conductive Hydraulic Fluid for "Jaws of Life"
  • IR ARO LogoFluid handling Pumps, Pump Packages and Accessories
  • BINKS LogoPaint Spray, Fiberglass & Gelcoat Equipment & Parts
  • ConProTech Inc. LogoMIXPAC 2 Component Point of Application Metering Dispenserts & STATOMIX Motionless Mixers
  • Devcon LogoMaintenance, Repair, Production, and Tooling Epoxies, Urethanes, Adhesives and Sealants
  • ES LogoTool & Accessories for Fiberglass, Rollers, Brushes, Demolding Wedges, Squeegees
  • GlasCraft LogoFiberglass, Gelcoat, Urethane Form Application Equipment & Parts, High Performance 2, Component Coating Equipment
  • National Starch & Chemical LogoWater and Solvent-based Industrial and Packaging Adhesives, BONDMASTER Hot Melt Adhesives, Contact, Wood Assembly, Packaging, Epoxy and Insulation Adhesives
  • Purolator Advanced Filtration LogoComplete Line of HVAC & Paint Booth Filters, Disposables, Poly-link, Pleated, Multi-Pocket, Polycube, Bulk Roll Media, Auto Rolls, Pad & Frame, HEPA Filters
  • LPS LogoIndustrials Lubricants, Penetrants, Degreasers, Corrosion Inhibitors
  • Permabond Engineering Adhesives LogoPERMABOND Cyanoacrylante Adhesives, PERMALOK, Anaerobic Sealants
  • SANTOLUBES LogoElectronic/Electrical Contact Lubricants
  • PPG Industries LogoDispensing Equipment, Cartridges, Nozzles, Syringes
  • TAH LogoSyringes, Dispensers
  • Techcon Systems LogoDispensing Equipment, Caulking Guns, Cartridges, Nozzles
  • GRACO GUSMER LogoSingle & Plural Component Pumps & Dispensing Equipment, Urethane Foam Spray Equipment, Meter, Mix & Spray, Dispense Systems, Proportioning Equipment, Plural Components, High Performance Coatings Equipment
  • 3M LogoStructural Epoxy Adhesives and Applicators, Solvent-based & Water-based Adhesives & Applicators, Aerosol Adhesives, SCOTCH-WELD Structural Epoxy Adhesives, EPX Epoxy Adhesives & Application Guns, FASTBOND Contact Adhesives, SCOTCH-GRIP Industrial Adhesives, SCOTCH-SEAL Sealants/Adhesives, WEATHERBAN Sealants, JETMELT Hot Melt Adhesives & Guns, AEROSOL High Performance Aerosol Adhesives

TBM, Inc • 950 Kingsland Ave. • St. Louis, MO 63130 • 1.800.825.1128 • 314.721.5590 • fax: 314.721.4990

Web Design by Tower29 Marketing Group